Glow plug hole reamer for M10x1 sealing seat Angle 120°

If glow plugs are replaced, the glow plug hole should be cleaned with a special tool, as otherwise the attached cokings may result in heat accumulation on the new glow plug, and therefore overheating.
Achieving optimum sealing again is another important step. This is achieved by wiping dry the sealing cone with the appropriate reamer.
Tip: If the securing thread needs to be replaced using the thread bush, the seal seat needs to be wiped dry using a reamer, and adjusted.

Thread: M10x1
Sealing angle: 120°
Tip Ø: 4,7 mm
Tip Ø: 6,9 mm

Suited for:
Subaru - Boxer: Engine code EE20